Step 1: Simply place the SnapPad underneath the metal foot of the RV. Be sure to install your pads one at a time! And grab a partner - SnapPads are much easier to install with two people.
Step 2: Be sure your pad is properly aligned with your jack. You can lower the jack a few inches above the SnapPad to ensure the pad is centered. Lower the foot into the cavity and continue to apply pressure until the lip wraps over the edge of the foot. You'll know it's in place by the distinctive snap!
We recommend using some dish soap around the inner lip to help snap it into place. WARNING: Do not use petroleum based lubricants (i.e., Silicone or WD 40), as this can potentially erode the SnapPad.
Step 3: Now your SnapPads are permanently installed and ready to effortlessly level your RV across any surface. It's just that easy.
Step 4: Should your SnapPad not install, raise your foot 3” - 4", place a 1/4” shim on the side of the pad that hasn’t engaged, and lower the foot. The shim will help snap the pad into place.
For further instructions, check out our Installation Videos, we have one for each line of SnapPad products.
CAUTION! Be sure to keep your fingers away from pinch points while installing your SnapPad! Origen RV Accessories LTD is not responsible or liable in any way for any indirect or direct injury sustained during installation or future use of the product.
Origen RV Accessories LTD shall not be liable for any special, incidental, indirect, or consequential damages whatsoever (including but not limited to, labor, installation, charges, damages to associated equipment, RV, trailer, towing or following vehicle) arising from the use or inability to use or install the product.